The necessary equipment for a panel furniture factory or a whole-house customization factory is edge banding, material cutting, and drilling. Three types of equipment are needed. The drilling equipment six-sided drills are standard inLarge scale factories. If there is no six-sided drill, what should you do? Some customers may say that they can use a side-drilling machine. Yes, but there is a new model currently, which is a double-sided drilling and cutting integrated machining center.

Quick CNC new Launched! The third generation intelligent double-sided drilling and cutting integrated machining center is composed of a swing arm loading unit, a through-type punching unit, a labeling machine, and a high-speed dust-free unit. The processing efficiency is 140-170 sheets/8H, according to the market Customers have to continuously optimize and upgrade the user experience. In terms of loading, the material is suspended to avoid bumps and scratches on the plates caused by traditional loading methods. The labeling process has also been adjusted to completely eliminate label wear during the drilling process. Further optimize the workload distribution of drilling, milling and cutting, reduce idle waiting, and increase the efficiency by 30% compared with the previous generation solution. The reserved port for equipment connection can be connected with the KF-53KST edge banding and side hole all-in-one machine to form a complete line to complete all processing steps of the board. In this way, you only need two pieces of equipment to open a whole-house customization factory. You need With less equipment and a small footprint, costs are also reduced.